Precision Mold Design & Manufacturing

149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray

ZINITEK single-station blanking die for 2 mm sheet with an animated 3D model. Discuss a die design for your drawing or sample part.

3D model of 149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray

3D model

The view-only 3D model shows the upper and lower die, the 4-pillar guiding and the strip, driven by the press crank: the stripper clamps the strip, the punch cuts the blank, the blank drops into the tray and the strip feeds one pitch. The “Architecture view” button fades the plates so the punch, springs and the blank falling into the tray can be seen.

Main design

An 8-piece sectional die sits in a die housing; the 149.8 × 158 mm punch is mounted in the punch holder. The stripper hangs on 4 shoulder bolts with 12 rectangular-wire springs seated in deep pockets. Blanks pass through the die into a drawer-type tray between the parallels; the 2 mm strip is located at a 152.1 mm pitch by a hole stop.

Discuss a die for your part

Send a drawing or sample with material, thickness, volume and press data, and ZINITEK will discuss the design and manufacturing options.

Send a die design or manufacturing request

Project Gallery

149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray 1
149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray 2
149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray 3
149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray 4
149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray 5
149.8 × 158 mm Blanking Die with 8-Piece Sectional Die and Blank Tray 6